Dodge 5.9 Cummins Throttle Linkage 89-91.5

Description

Replacement throttle linkage for 89-91.5 dodge cummins 5.9 with the VE style pump, Replaces Mopar 5011955AB
Will not fit 91.5 and up as it will be too short.
Turnbuckle style linkage for easy adjustment with steel ball and socket linkage with neoprene rubber seals to keep out dust, can be lubricated if desired.
length fully retracted is 4 3/4"
length fully
extended
is 5 3/8"
*If your required length is outside of these parameters this will not work for you*
Installation is simple with basic hand tools, unscrew the ball and socket on the pump, on the linkage side you will have to cut off the ball end, it is best to cut off the ball end on both sides using either a hacksaw or a cutoff wheel then popping out the remaining piece. That can be done on the engine or off whichever is easier.
With both the pump and linkage in there full closed state adjust out the rod equally until it fits in both holes, tighten the lock and jam nuts and make sure it cycles smoothly.
The below link is for the linkage that fits 91.5-93
http://ebay.us/m2p0Zk?cmpnId=5338273189